The 2025 RMK PRO and RMK Khaos sleds are no longer equipped
with the pre-punched lower front skid arm drop hole from the factory -
we recommend the front arm drop for anyone running our taller ELEVATE
spindles on an RMK to balance machine front to rear. This kit allows you
do make this key geometry change on your 2025+ Polaris Matryx PRO or
KHAOS.
When to run your front arm dropped - our recommendations:
PRO RMK: dropped front skid arm recommended on ALL models
when installing ELEVATE spindles. Can also be installed without ELEVATE
spindles for a more playful feel. Can be switched between factory
position and dropped depending on conditions and desired handling.
RMK KHAOS: dropped front skid arm recommended on ALL models
when installing ELEVATE spindles. You can install this without ELEVATE
spindles as well but steering will be very light on the front end and
limit climbing ability. Can be switched between factory position and
dropped depending on conditions and desired handling.
** You still retain full use of your factory upper skid arm hole with
this kit, so the geometry change is 100% reversible if you wish to do
so, just re-bolt the front skid arm back in the factory hole in the
tunnel, which is retained**
CLICK HERE FOR INSTALLATION VIDEO HOW-TO
Our '25 + Front Arm Drop Kit for Polaris MATRYX RMK/KHAOS includes:
- Custom 2-positon backer plate (steel)
- Rivet punch
- 3/16" drill bit for removing & adding new rivet holes
- Center punch for locating drop position
- 13/32" drill bit for new drop position
- New rivets for installation
SOLD AS A PAIR OF TWO BRACKETS AND HARDWARE - ORDER ONE KIT PER SLED
Share
Share on Facebook
Tweet
Tweet on Twitter
Pin it
Pin on Pinterest
